JVARIANCE 4/0 KIT completed...

Discussion in 'Reels' started by Team Buddahead, May 14, 2009.

  1. Team Buddahead

    Team Buddahead Member

    61
    0
    Well, I finished the assembly of the kit. It went together just fine.
    I did run into one problem, the clicker assembly was the pressed together style not
    the "c-clip" style. I did have a Accurate clicker that I was able to put on. Just
    remember to look at what style you have before you order yours.
    [​IMG]
    Here was where the fun begins...
    [​IMG]
    All the parts switched over..
    [​IMG]
    Lubed the reel seat, I didn't want metal to metal fit for the saltwater.
    Would be nice to see a nylon or rubber style gasket.
    [​IMG]
    The reel all done..
    [​IMG]
    [​IMG]
    [​IMG]

    It's going fishing this weekend...Not with me though..:mad:
     
  2. BretABaker

    BretABaker Guest

    any weight reduction before/after?
     

  3. Team Buddahead

    Team Buddahead Member

    61
    0
    Good question... I didn't weigh this one but I will be building another one next week. I will find out.
     
  4. jiggawhat

    jiggawhat Senior Member

    3,193
    442
    WHere did you get those rubber pieces on the free spool lever?
     
  5. Team Buddahead

    Team Buddahead Member

    61
    0
    You can get them at Lowes or Home Depo. I call them Thread Protectors. Just cut the closed end.
    [​IMG]