360 Tuna Fishers Forum banner
1 - 5 of 5 Posts

·
Moderator
Joined
·
4,723 Posts
Discussion Starter · #1 ·
Anyone know if model NO.LT-081 Jigging Master T-Bar Handle will fit an Alutecnos Gorilla 20? Any other recommendations for aftermarket aluminum T-Bar handles other than the JM ones? Thanks!
 

·
Moderator
Joined
·
4,723 Posts
Discussion Starter · #3 ·
I've not used it yet, I was just considering one of the aluminum ones cause it's probably lighter and looks much better than the factory one.
 

·
Senior Member
Joined
·
717 Posts
I would try it with the factory handle before spending 100 on a new one. IMO the factory one is comfortable, I would leave it alone.
 

·
SPONSOR
Joined
·
11,848 Posts
I would try it with the factory handle before spending 100 on a new one. IMO the factory one is comfortable, I would leave it alone.
I agree with stresst. I thought the handle of Accurate 12/20 is very nice. If you want to try JM LT-81, I'll send it to you. If it doesn't fit, return it to me. There are three different shafts of JM LT-81. one for Accurate, one for Daiwa and the other is for Shimano. I experimented a Accurate shaft for John Baker reel and it fit nicely.

 
1 - 5 of 5 Posts
Top