360 Tuna Fishers Forum banner
1 - 5 of 5 Posts

· Senior Member
Joined
·
1,636 Posts
Discussion Starter · #1 ·
This was a shot of the stock Daiwa handle. I had a little trouble, because I initially didn't see the top bearing down in the handle.



This was the layout I used for the new handle.



The shaft greased and installed. I've got a little dab of grease on the threads and now ready for the handle. Some may recommend oil, but I like grease.



The finished product

 

· Senior Member
Joined
·
1,636 Posts
Discussion Starter · #3 ·
The handle is universal, you just need to specify what shaft you need. When you take off the stock handle there are two thin washers, then the bearing. Take something and poke it up through the handle and the second bearing will pop out the top as shown in the first sequence. The JM shaft comes with another thin washer that I used on top. Its the brass colored one.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top