360 Tuna Fishers Forum banner

How to replace knob on Jigging Master Wiki reel?

857 Views 14 Replies 5 Participants Last post by  day0ne
Instructions looked pretty easy until the head of the screw broke. Not sure if it had loctite on it or not?


This is a wiki 2000h
Wood Automotive design Gas Propeller Propeller
See less See more
1 - 1 of 15 Posts
Makes sense! So it’s just glue and pressure holding the shaft in. Once the screw broke off their is noting permanently holding the shaft anymore. So what Explorer said is a good idea, heat, grab hold and twist it off. Good Luck!

Nope! There is still the matter of the small screw inside the knob that is threaded into the opposite end of the shaft to remove.
1 - 1 of 15 Posts