epoxy ramp

Discussion in 'Rod Building' started by bingfish, Dec 18, 2008.

  1. Dec 18, 2008 #1
    bingfish

    bingfish Senior Member

    597
    42
    Good afternoon Gentlemen, this is my first post on this site. You guys are tuna maniacs! Loving what I'm seeing/learning so far. I've been building rods for a while now, mostly small stuff for wade fishing the laguna madre here in south Texas. Trying my hand at epoxy ramps for some re-builds for a friends #80 trolling rods. Got the general idea, but, could sure use some advice. Thanks alot.
     
    bingfish, Dec 18, 2008
    bingfish, Dec 18, 2008
  3. Dec 18, 2008 #2
    Eastern Tackle

    Eastern Tackle Senior Member

    1,657
    33
    Eastern Tackle, Dec 18, 2008
    Eastern Tackle, Dec 18, 2008

  5. Dec 18, 2008 #3
    paul708

    paul708 Site Sponsor

    4,160
    205
    they are pretty easy to do.
    5 minute epoxy shapes pretty nice.
    just practice a few.

    the videos there give a good idea of what to do.
     
    paul708, Dec 18, 2008
    paul708, Dec 18, 2008
  6. Dec 18, 2008 #4
    bingfish

    bingfish Senior Member

    597
    42
    Thanks a million guys, best advice/info. I've gotten yet. Much appreciated!!
     
    bingfish, Dec 18, 2008
    bingfish, Dec 18, 2008
  7. Dec 18, 2008 #5
    Fishhead56

    Fishhead56 Senior Member

    1,086
    1
    bingfish,

    Welcome to this board.

    Not only tech stuff here, Tell us a story too if you like from LLM.

    K2
     
    Fishhead56, Dec 18, 2008
    Fishhead56, Dec 18, 2008
  8. Dec 19, 2008 #6
    bingfish

    bingfish Senior Member

    597
    42
    Actually headed down to Baffin today. Will probably wade for monster trout tommorow( I'ts Corky time!!), and fish PINS for pompano on sunday. Will post the results and pics on Monday. Thanks for the Welcome, Great site!
     
    bingfish, Dec 19, 2008
    bingfish, Dec 19, 2008