360 Tuna Fishers Forum banner
21 - 25 of 25 Posts

· Registered
Joined
·
2 Posts
I formed a bearing puller for my Penn 330 GTI, I pulled the spool axle bearing out of the left side plate unfortunately the new bearing was too small so I pried the bearing cover off and lubed up the old one and put it back in. I need to pull it out after I try it on halibut Saturday. I'll mic it and hopefully get one from Alan that's the proper diameter.
 
21 - 25 of 25 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top