Separate names with a comma.
trying to remove the TBar, not the SS shaft. :) TBar Loctite and trying to heatgun this screw threat here.
trying to avoid this but if it comes down to that..... oh well.:cool:
[ATTACH] Sorry I was at work so didn’t spend enough time to reply the way I should. I am trying to take out this TBar out and I used too much...
Pressed, welded or stamped.....heat gun will not loosen it correct?
They always picked the laziest in the store to do the heavy lifting :p:p
I hope someone tried it and tell us how easy it is with the “needle”. Breaking strength is one thing, not easy with needle high blood pressure
Don’t curse me Benny!! LOL:D
Been wanting the GHP-76-100 . Wait for Covid to [email protected] off and I can drive down to pick up one
Taiwan, JM is in Taipei.
NO.9,LANE 64, DONGXIN ST., NANGANG DISTRICT, TAIPEI CITY 11576,TAIWAN(R.O.C.)
Office Ph +886-2- 27859515
Yup:) looks like they still have 2000H and 2000XH left
(I managed to load)
Wiki 2000 ~ PE-line 0.32mm 400yards
Wiki 3000 ~ PE-line 0.36mm...
- synchronize level wind feature.
- retrieve speed is faster than PowerSpell as well but they compensated it with a longer power arm...
[ATTACH] Hi ALL,
anyone know if this “ shaft” is screwed on or welded on?
*picture stolen from AlanHawk website*
JM Wiki reels you taking about?
EverGreen Poseidon Slow Jerker